A.M. Metal Finishing Inc.

For all your finishing needs
Call us at (407) 843-0182

Teflon / Nylon / Thermoplastic Coatings

In most cases substrates are prepared for coating by degreasing and grit blasting. Coatings are then applied with either conventional spray guns, electro-static powder equipment or fluidized beds. The coated products are then heat cured in carefully monitored custom ovens.

To request more information, click here.

Teflon/Nylon/Thermoplastic Benefits

Teflon/Nylon/Thermoplastic Coatings

For more information concerning Teflon/Nylon/Thermoplastic Coatings, download our Coating Reference Guide.

Lubricant, Solid Film [MIL-L-46010D]

A solid film lubricant renders a service permanently lubricated, giving rise to the elimination of wet lubes. The applications vary as do the coatings. From MoS (molybdenum disulphide) to PTFE (polytetrafluoroethylene) compounds are blended to meet specific needs. Low VOC coatings are available in both organic and inorganic solid film lubricants as well as corrosion inhibitive coatings. This Mil Spec establishes the requirements for three types of heat cured solid film lubricant that are intended to reduce wear and prevent galling, corrosion and seizure of metals. Compliance: all items must meet Sections 3 and 5 of the Spec. For use on aluminum, copper, steel, stainless steel, titanium and chromium and nickel bearing surfaces. Thickness range: .0003" - .0005"mm. No single reading less than .0002" or greater than .0007"

To request more information, click here.

Lubricant, Solid Film [MIL-L-46010D] Types

Type I: A cure temperature of 300°F ± 60°F and endurance life of 250 minutes.

Type II: A cure temperature of 400°F ± 60°F and endurance life of 450 minutes.

Type III: A low volatile organic compound (VOC) content lubricant with cure cycles of 300°F ± 60°F for one hour an endurance life of 450 minutes.

Color 1: Natural product color

Color 2: Black color